Each BCM Current Monitoring Kit with Split Core CT Termination Modules comes complete with:
Qty. 1 VPE-1911 BCM I/O Module
Qty. 1 VPE-2305 Split Core CT Termination Module for up to 21 CT's
Qty. 1 Ribbon Cable 26 Pin to 26 Pin, 3' Long
Picture shows a short cable for demonstration purposes only.
At the heart of the system is the VPE-1911 42 point Current Transformer I/O Module.
-
Low Power (12 - 24 VDC), Nominal 24 VDC, Supplied via CAT5e Cable
-
Up to 42 Current Transformers, 21 CT's Max per Ribbon Cable connection
-
CT Load Resistor = 50 Ohms (100 Ohms on each Interface Channel, 100 Ohms on each channel on the VPE-2051 CT Strip and 100 Ohms on each channel on the VPE-2305 break out module)
-
True RMS Current Measurement
-
RS-485 Output, Half Duplex, Fault Tolerant Isolated Driver IC, 2 x RJ45 Jack (Power and Data)
-
MODBUS RTU Protocol, ID Dipswitch Selectable, Baud Rate Jumper Selectable (9600 or 19.2K Baud)
-
ICE FPGA as Main Processor
-
High Precision 16 bit A/D Converter
-
1500 VAC Isolation Between Signal Conditioning and Communication Circuits
-
DIN Rail Enclosure 4.375" DIN Length x 3.5" Wide x 1.375"High (Above DIN Rail)
-
LED Indicators, Power (Blue), RS485 Tx(Red) and Rx (Green), Fault (Red), Heatbeat (Green)
